Textile Winding, Twisting, and Drawing Out Machine Setters, Operators, and Tenders
Core Tasks Include:
- Notify supervisors or mechanics of equipment malfunctions.
- Start machines, monitor operation, and make adjustments as needed.
- Inspect products to verify that they meet specifications and to determine whether machine adjustment is needed.
- Tend machines that twist together two or more strands of yarn or insert additional twists into single strands of yarn to increase strength, smoothness, or uniformity of yarn.
- Replace depleted supply packages with full packages.
- Observe operations to detect defects, malfunctions, or supply shortages.
- Thread yarn, thread, or fabric through guides, needles, and rollers of machines.
- Operate machines for test runs to verify adjustments and to obtain product samples.
- Inspect machinery to determine whether repairs are needed.
- Record production data such as numbers and types of bobbins wound.
- Stop machines when specified amount of products has been produced.
Supplemental Tasks Include:
- Tend machines with multiple winding units that wind thread onto shuttle bobbins for use on sewing machines or other kinds of bobbins for sole-stitching, knitting, or weaving machinery.
- Place bobbins on spindles and insert spindles into bobbin-winding machines.
- Tend machines that wind wire onto bobbins, preparatory to formation of wire netting used in reinforcing sheet glass.
- Study guides, samples, charts, and specification sheets, or confer with supervisors or engineering staff to determine setup requirements.
- Measure bobbins periodically, using gauges, and turn screws to adjust tension if bobbins are not of specified size.
- Install, level, and align machine components such as gears, chains, guides, dies, cutters, or needles to set up machinery for operation.
- Tend spinning frames that draw out and twist roving or sliver into yarn.
- Unwind lengths of yarn, thread, or twine from spools and wind onto bobbins.
- Observe bobbins as they are winding and cut threads to remove loaded bobbins, using knives.
- Adjust machine settings such as speed or tension to produce products that meet specifications.
- Clean, oil, and lubricate machines, using air hoses, cleaning solutions, rags, oilcans, and grease guns.
- Remove spindles from machines and bobbins from spindles.
- Repair or replace worn or defective parts or components, using hand tools.
The data sources for the information displayed here include: O*NET™. (Using onet27)